Solutions: Apache's RAM Usage
First and most obvious, Apache processes use a ton a RAM. This minor issue becomes a major issue when you realize that after each process has done its job, the bloated process sits and spoon-feed data to the client, instead of moving on to bigger and better things. This is further compounded by a bit of essential info that should really be more common knowledge:
If you serve 100% static files with Apache, each httpd process will use around 2-3 megs of RAM.
If you serve 99% static files & 1% dynamic files with Apache, each httpd process will use from 3-20 megs of RAM (depending on your MOST complex dynamic page).
This occurs because a process grows to accommodate whatever it is serving, and NEVER decreases again unless that process happens to die. Quickly, unless you have very few dynamic pages and major traffic fluctuation, most of your httpd processes will take up an amount of RAM equal to the largest dynamic script on your system. A smart web server would deal with this automatically. As it is, you have a few options to manually improve RAM usage.
Reduce wasted processes by tweaking KeepAlive
This is a tradeoff. KeepAliveTimeout is the amount of time a process sits around doing nothing but taking up space. Those seconds add up in a HUGE way. But using KeepAlive can increase speed for both you and the client - disable KeepAlive and the serving of static files like images can be a lot slower. I think it's best to have KeepAlive on, and KeepAliveTimeout very low (like 1-2 seconds).
Limit total processes with MaxClients
If you use Apache to serve dynamic content, your simultaneous connections are severely limited. Exceed a certain number, and your system begins cannibalistic swapping, getting slower and slower until it dies. IMHO, a web server should automatically take steps to prevent this, but instead they seem to assume you have unlimited resources. Use trial & error to figure out how many Apache processes your server can handle, and set this value in MaxClients. Note: the Apache docs on this are misleading - if this limit is reached, clients are not "locked out", they are simply queued, and their access slows. Based on the value of MaxClients, you can estimate the values you need for StartServers, MinSpareServers, & MaxSpareServers.
Force processes to reset with MaxRequestsPerChild
Forcing your processes to die after a while makes them start over with low RAM usage, and this can reduce total memory usage in many situations. The less dynamic content you have, the more useful this will be. This is a game of catch-up, with your dynamic files constantly increasing total RAM usage, and restarting processes constantly reducing it. Experiment with MaxRequestsPerChild - even values as low as 20 may work well. But don't set it too low, because creating new processes does have overhead. You can figure out the best settings under load by examining "ps axu --sort:rss". A word of warning, using this is a bit like using heroin. The results can be impressive, but are NOT consistent - if the only way you can keep your server running is by tweaking this, you will eventually run into trouble. That being said, by tweaking MaxRequestsPerChild you may be able to increase MaxClients as much as 50%.
Apache Further Tweaking
For mixed purpose sites (say image galleries, download sites, etc.), you can often improve performance by running two different apache daemons on the same server. For example, we recently compiled apache to just serve up images (gifs,jpegs,png etc). This way for a site that has thousands of stock photos. We put both the main apache and the image apache on the same server and noticed a drop in load and ram usage. Consider a page had about 20-50 image calls -- the were all off-loaded to the stripped down apache, which could run 3x more servers with the same ram usage than the regular apache on the server. |
发表于 2009-12-11 22:13
|